Moving Bogen paging system to RingCentral

  • 0
  • 1
  • Question
  • Updated 2 months ago
  • Answered
We currently have a Bogen UTI312 connected to a SPA800 through our current carrier.  We are in the process of migrating to RingCentral but RC support says they do not support SPA8000.  Will SPA122 work in this instance?  We only have 1 zone (entire building).
Photo of ADIM Matt

ADIM Matt

  • 100 Points 100 badge 2x thumb

Posted 2 months ago

  • 0
  • 1
Photo of Brandon

Brandon, Champion

  • 22,610 Points 20k badge 2x thumb
It should.  One thing I would watch for or try to figure out in advance is how to configure the SPA to send disconnect signal to the UTI after the page announcement ends.  Without it you can end up with hearing busy tones after each page for up to 30 seconds..
Photo of Michel

Michel, Champion

  • 3,010 Points 3k badge 2x thumb
also, obviously, you may need (4) SPA122 units to provide the same 8 analog lines you have available with your SPA800 unit (if you are using all the lines)
Photo of ADIM Matt

ADIM Matt

  • 100 Points 100 badge 2x thumb
Thank you for the quick responses.  There is only 1 analog line and it pages to the entire building, so the SPA122 seems to be the logical choice since RC does not support the SPA8000.  I just wanted to make sure it was the correct choice, I didnt see many options in the admin portal.