We are using the Yealink T48S desk phones. When someone starts dialing a number, if there is more than a 2 second delay in finishing the number, the phone auto dials what is already there. The call of course then doesn't go through. Using information found on the internet, I found where I am supposed to be able to increase that time. However, it's not working. Anyone have any thoughts or have dealt with this themselves?
Extend Dial Time on Yealink T48S
Userlevel 3
If you have access to the backend GUI - it's under Settings / SIP / Digitmap Timeout - there's a second count for each of the Digitmappings directly above. We found 4 to be too long, and have impatient users, and set ours to 2 seconds for each.
should look like:
3|3|3|3|3
for as many mappings you have. The 'pipe' is the shifted character above the Enter key. ( | )
Hope that helps.
I logged into the GUI of the T48S and am not seeing that Digitmap Timeout option. Under SIP, all I have is a few SIP session Timers and a couple of SIP Ports.
Userlevel 3
Well, don't I feel sheepish - I was provisioning a Polycom when I saw the message and just switched screens... If you're ever on a Polycom - that's where that setting is.
Yealink: Under the Settings / Preferences tab:
Let me know.
No worries. It's been one of those weeks for me as well. :)
I did find that setting and changed it to 10s with both the 'Live Dialpad' option enabled and disabled. Unfortunately, that didn't help. It's still autodialing if I pause more than ~1.5 seconds when typing in a number.
Maybe with this being a RingCentral phone, they did something to the firmware to ignore those settings?
Check my comments above. It was user error opening a line and expecting the phone to know not to dial out.
If you hear a dial tone you can expect it to dial out as soon as a pause (2 sec) occurs no matter what setting is applied.
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.