We bought into ringcentral through spectrum and they assured me this would work. It doesn't and I want to make sure I purchase what I need to fix this disaster. I've seen the bogen tamb2 used to bridge the gap from the ata to the amp. Anyone familiar with this? I also emailed valcom and they said their VRCPA paging adapter would work with ring central without the ATA. Any help is appreciated.
Hey...I've always used an Algo 8301 to access paging. It doesn't take a license and it costs like $300.00. You can get it off amazon. You plug it into the network, press the button to get the IP, (you will need a stereo plug headset) log into the interface, Log into your RC portal and follow the directions. there are specific articles on how to install and it's pretty seemless. the code is set by RC it's like *84 then you hit the access code of 1-9 I think. if you are using the ATA you need to covert the analog to a 600ohm. I always use a Viking RAD 1A but the TAMb works as well. Use Station IN, then Page out to your bogen amp pins. Algo_RingCentral Provisioning Guide(1).pdf
Hope this Helps-
Philipn@mtvoip.com
What is the stereo plug headset for?
after you let the algo boot up, you can push the button on the unit with a paper clip and it will read you back the IP address of the unit. That way I don't have to bug them for the IP off the network. Hope this helps
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.