I was puzzled by the fact that about 5 minutes were used per call log for phone calls I did not pick up on. Support indicated this was because my outgoing message was being repeated 3 times, giving caller 3 chances to leave a message. I would prefer this be a setting for me the user to set (to 1 time) for my outgoing message, rather than have RC repeat my outgoing message 3 times. Given all the settings I could configure, I was surprised that this setting (repeat outgoing message 3 x) was hard-wired by RC, and configurable by me.
Could number of times my outgoing message repeats be placed under my control?
Hey, Craig! Thanks for reaching out! This feature does not exist at this time, but we encourage you to share it in our Ideas Portal. Click here to make your way over.
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.