Trying to setup the page extension in the Basic Settings with the info given by Ring Central. I keep getting no reply from server under the SIP Registration under Status. Any guidance would be greatly appreciated.
The 8301 is only going to be used for overhead paging only.
When creating the paging device did you enable TLS? I have seen enabling that cause some issues.
You put all the info inside the ALGO GUI right?
I’m having the same exact issue. I feel like I have tried everything and still get a “No reply from server” error.
I have TLS off. I put in the Username and password in the Basic SIP settings. Where does the Authorization ID go?
I have TLS off. I put in the Username and password in the Basic SIP settings. Where does the Authorization ID go?
Would you happen to be able to share a screenshot of you Algo Web GUI settings? It would also be helpful if you could send a screenshot of your Paging device Provisioning info, mine was there just as a reference point
Thank you for sending this!
Have you tried entering the Username into the Page extension field, the authorization ID in the authentication ID section and the password in the password section. In advanced SIP settings did you put in the outbound proxy information? (you will need to select based on where you are located of me its NA EAST)
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
