We are using the Yealink T48S desk phones. When someone starts dialing a number, if there is more than a 2 second delay in finishing the number, the phone auto dials what is already there. The call of course then doesn't go through. Using information found on the internet, I found where I am supposed to be able to increase that time. However, it's not working. Anyone have any thoughts or have dealt with this themselves?
If you have access to the backend GUI - it's under Settings / SIP / Digitmap Timeout - there's a second count for each of the Digitmappings directly above. We found 4 to be too long, and have impatient users, and set ours to 2 seconds for each.
should look like:
3|3|3|3|3
for as many mappings you have. The 'pipe' is the shifted character above the Enter key. ( | )
Hope that helps.
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
